Display multiple forms at runtime [message #425934] |
Tue, 13 October 2009 04:40 ![Go to next message Go to next message](/forum/theme/orafaq/images/down.png) |
meim
Messages: 35 Registered: July 2009
|
Member |
|
|
Hi,
is there a way to keep the display of the form when we call another new form. my scenario will be as following:
am in form1 , i call form 2 from a menu, after this call form2 is open in place of form1.
i have no control in form1 and i can't change anything on it, i don't know hw the menu option is calling form2.
the only control i have will be within form2 if there is any change i can make it.
i read something about MDI, and OPEN_FORM() procedure, but i think this will required a change in form1 which i can't do.
is there any change i can make in form2 to display it and keep the display of form1 at the same time behind it ?
Regards,
Meim
|
|
|
|
|
Re: Display multiple forms at runtime [message #507886 is a reply to message #507883] |
Wed, 18 May 2011 06:54 ![Go to previous message Go to previous message](/forum/theme/orafaq/images/up.png) ![Go to next message Go to next message](/forum/theme/orafaq/images/down.png) |
cookiemonster
Messages: 13937 Registered: September 2008 Location: Rainy Manchester
|
Senior Member |
|
|
Wow. You've resurrected a 2 year old thread to give an answer that requires the OP to do something they specifically say they can't - change form 1. That's really unhelpful.
And you've posted all in capital letters, which is considered shouting in internet forums - don't do it again.
|
|
|
|
|